Free shipping Gas Soldering Iron - HT-1937 Torch Tool Tip use Butane Pen | Инструменты

---

Free shipping  Gas Soldering Iron - HT-1937 Gas Soldering Iron Torch Tool Tip use Butane Gas  Pen Soldering Iron

Free shipping 

Pen Soldering Iron
 - HT-1937
Gas Soldering Iron Torch Tool Tip use Butane Gas  Pen Soldering Iron
Name: pen type gas soldering iron
Model: HT-1937
Filling capacity: 12ml
Temperature: flame temperature of 1300 degrees, soldering iron temperature of 450 degrees
Material: Plastic + Metal
Instructions for use
First, the filling gas
1, the use of high-quality gas filling, and confirmed at the OFF switch is turned on, and then supplement the.
2, the gas tank is imported into the pores, under pressure inflatable.
3, about 10 seconds, to be completed by filling gas, wait a few minutes, so that gas stability, re-use.
4, if the gas poured, the tail outlet hissing sound, a little pressure with the tip of the pen into the air intake, you can eliminate.
Second, the ignition
1, put the tip
2, push the switch to the ON to hear a "hissing" sound.
3, with the igniter or a lighter, ignition near the joint.
4, on fire, burning for 3 minutes, until the fire was put out less, the tip will continue to heat.
5, adjust the size of the flame to "ten" in the direction to the direction of the ".
This product temperature up to 1300 degrees (iron temperature 450 degrees), use should pay attention to safety, exhausted after switch is turned off to the OFF position.
7, using a gas soldering iron, please pay special attention to have to wait until the flame completely eliminate soldering iron objects red line operation, the flame size is not large, in order to extend tip life.
8, the flame length of about 1.2-2.2 cm.
Third, pay attention:
1, replace the connector, to be cool down, replaced or changed in advance.
2, the tip of the use of high temperature and hot, do not touch it.
3, the adjustment knob can control out of gas and the temperature of the gas, can usually placed in the middle position.
4, after use and after cooling, re-collection, not away from heat or direct sunlight.
5, children should not be used, must be placed properly at the collection.
6, use high-quality canned gas fill, fill away from the fire source.
7, Yin Wasi or more less have some residue quality, regular cleaning nozzle is necessary.
8, Clean the nozzle is pressed on the gas tank outlet jet up to the cleaning effect.
9, to avoid Zhongshuai.
10,  When any case, do not try to disassemble or repair.